Siemens Gigaset A58H Instructions Manual page 10

On the handset:
¢ ¢
Settings
§Menu§
(If you require further information on the illustration of these operating steps,
¢
please see page 17.)
~
Enter the system PIN of the base station (the default is 0000) and
press
§OK§
Handset is
registering
ë
On the base station:
Within 60 sec. press and hold the registration/paging key on the base station
(approx. 3 sec.).
The following is displayed after successful automatic or manual handset
registration:
Ð V
Þ
Menu
The handset is assigned the lowest unassigned internal number (1–4). If more
than one handset is registered to the base station, the internal handset number
appears on the display, e.g.
assigned to other devices, the number 4 will be overwritten.
To charge the batteries, leave the handset in the base station/charging cradle.
Please note
Only place the handset in the base station or charging cradle that is
intended for it.
Should you have any questions and problems
¢
Handset Register Handset
.
The registration screen is displayed.
u
the strength of the reception signal between
base station and handset:
– good to poor: Ð i Ñ Ò
– no reception: | flashes
u
battery charge status:
– = e V U (flat to full)
– = flashes: batteries almost flat
– e V U flashes: charging procedure
INT 2. If the internal numbers 1–4 are already
¢
page 26.
First steps
9