Battery Charging - Motorola L6Q Installation Manual

Figure 6: Battery Installation
2.7

Battery Charging

The internal Camera Batteries must be fully charged before proceeding with Hardware Installation. For
solar panel deployments, the Solar Panel Batteries must also be fully charged. Charging all batteries at
the same time is recommended, as they have similar charging times.
NOTE: Failure to fully charge the Camera Batteries and Solar Panel Batteries before installation
may cause the batteries to die before there is sufficient power to keep them charged under
load.
Table 16: Battery Charging Times
Method
AC Power Adapter
USB-C Cable and USB-C Power Adapter (25W)
2.7.1
Charging the Camera Batteries
Prior to installation, the internal Camera Batteries must be charged using the optional AC Power
Adapter or the included USB-C cable. To charge by USB-C cable, a USB-C Power Adapter or USB-C
power source capable of 25 Watts is strongly recommended. Lower amperage USB power sources will
charge the camera batteries very slowly.
Prerequisites: Obtain one of the following:
• AC Power Adapter
• USB-C Charging Cable and USB-C Power Adapter (25W)
The internal Camera Batteries have been installed.
Procedure:
1 Select one of the following options for charging the Camera Batteries:
Option Actions
To use perform the following actions:
the USB-
Approximate Time
Camera Batteries: 4–6 hours
Solar Panel Battery: 6–8 hours
Camera Batteries: 6–8 hours
MN010089A01-AB
Chapter 2 : Pre-Installation
37