Mitsubishi Electric JT-MC106G-W-NA Handbook page 20

Assembly precautions
• Run the heater lead wires as shown in the picture at right.
• Fit the thermal fuse parts into the groove of the heater fittings.
(Indicated by )
(6) Blower (assembly) (Thermal fuse of the motor)
1 Disconnect the blower lead wires from the power circuit board (JT-
33P). → See (4) 1 to 2 and 6 to 7.
2 Push the cord bush into the blower cover. (Indicated by )
Assembly precautions
• Install the cord bush as shown in the picture at right.
• Make sure that there is no slack in the lead wires inside the blower
cover.
3 Unscrew the duct clamping screw.
(One PTT screw 4 x 14, indicated by )
Assembly precaution
Set the duct in the groove of the blower cover. (Indicated by )
─ 20 ─
Blower cover
Cord bush
Duct