Bosch SHXM65Z Series Operating Instructions Manual page 44

en-us Troubleshooting
Dishwasher Door may be ajar or not be properly
does not start. latched.
No power to the dishwasher (dis-
play won't come on). Fuse may
have been blown, circuit breaker
may have tripped, power cord may
have been unplugged or dish-
washer may have been turned off.
Can't select a wash cycle since the
previous wash cycle may not have
finished or the dishwasher hasn't
been reset.
Delay start or Child lock may be
activated.
The door may have been closed
without selecting a wash cycle.
Water supply may not be turned on
or connected.
Wash cycle The door has been open for more
won't resume than 4 seconds after pressing the
after door was Start button.
opened and
closed.
Display does A fuse may have been blown or cir-
not illuminate. cuit breaker tripped.
Door not closed or latched.
Note:
top of the door, the display only illu-
minates when the door is opened
and controls are visible.
Door does not Too small a gap between the top of
open automati- the dishwasher and the countertop.
cally at the end
of the cycle
Door and door seal are dirty.
with the Auto
Air option.
The unit is not level.
44
For models with controls on
Close door securely until door latch clicks.
Replace blown fuse or reset tripped circuit
breaker. Plug power cord into outlet
securely. Press the on/off button ( to
turn the dishwasher on.
Reset the dishwasher by pressing and hold-
ing the START button for at least three sec-
onds.
Reset Delay start or Child lock functions
(refer to the appropriate section in this man-
ual). ~ "Delay Start" on page 34
Select a wash cycle and close the door.
Check and turn on water supply.
Press Start button again and close the dish-
washer door within 4 seconds (see "Protec-
tion against unintentional operation" section
in this manual).
Check the fuse or circuit breaker box and
replace the fuse or reset the breaker if nec-
essary.
Ensure door is properly latched and com-
pletely closed.
Be certain there is at least a 6mm gap;
lower the dishwasher if needed. (See instal-
lation instructions)
Clean door and door seal with a damp cloth
and a small amount of dish soap.
Level the unit from right to left and front to
back. See installation instructions.