PROBLEM
Unable to access to
Operator 1
Unable to make
reconnection when the line
is busy.
Unable to make a no-
response reconnection.
Unable to generate a call
waiting tone from the VPS.
Unable to make an Intercom
Paging for groups.
PROBABLE CAUSE
•
Improper setting of the
operator extension number.
•
Improper setting of the busy
signal reconnection
procedure.
•
Improper setting of the no-
response reconnection
procedure.
•
Improper setting of sequence. •
•
Improper setting of the
Intercom Paging access
code.
POSSIBLE SOLUTION
•
Adjust the operator extension
number to that of the
connected PBX (see
"Operator's Extension" in
2.4.3 Parameters in the
Programming Manual).
•
Adjust the busy signal
reconnection procedure to
that of the connected PBX
(see "Reconnect Sequence on
Busy" in 2.5.4 Parameters in
the Programming Manual).
•
Adjust the no-response
reconnection procedure to
that of the connected PBX
(see "Reconnect Sequence on
No Answer" in 2.5.4
Parameters in the
Programming Manual).
Adjust the Call Waiting
sequence to that of the
connected PBX (see "Call
Waiting Sequence" in 2.5.4
Parameters in the
Programming Manual).
•
Adjust the Intercom Paging
access code to that of the
connected PBX (see "Paging
Code" in 2.5.4 Parameters in
the Programming Manual).
7.6 Troubleshooting
Installation Manual
231