Samsung ARTIK 530s Manual page 29

Table of Contents

Samsung Semiconductor, Inc.

4. Set up the PuTTY console with the following parameters:

–

Serial line is the COM port number found previously as described above

–

Set speed to 115200

–

Set connection type to Serial

–

Name and save the session. That way it can be reopened later by double-clicking on the saved session

name

5. Click Open. Initially, the screen will be blank.

Reset the ARTIK Module

6. Reset the ARTIK development kit by pressing and holding the ARTIK module PWR_KEY button until the

PWR_KEY LED next to the button goes off. This LED which is located right next to the PWR_KEY button on the

Interposer board. Then press and hold the PWR_KEY button again until the LED comes back on. For the exact

location of this button, refer to Figure 3.

When prompted to log in, use the following:

–

password: root

After entering the login and password, the ARTIK development kit displays a Linux window similar to the one shown

below:

Arrow.com.

Downloaded from

ARTIK 530s Development Kit

Table of Contents