Table of Contents
Advertisement
3. Press OK and the screen will display ADD
4. Press OK and the screen will display SEL DIGIT
5. Press a digit (1-9) for the scene you wish to add the device to. Press SHIFT and the digit (1-9) if
you are adding devices to scenes 10 through 18.
6. Press OK and the screen will display SETUP WAITING
7. Press the button on the device that you are adding. Adjust the brightness level on the device
within 30 seconds (refer to the manual for the device).
8. When the screen displays SUCCESS, you have successfully added the device to a scene.
To control a scene:
1. Press SCENE once to put the remote in SCENE Mode. The remote will stay in this mode until the
Light, Group or All mode is activated.
2. Press the digit key for the scene you wish to control (1-9). Press SHIFT and the digit (1-9) if you
are controlling scenes 10 through 18. The screen will display scene and the digit selected.
Removing a Light (Device / Node) from a Scene:
This only removes the device from a specific scene. The device is still part of your home control
network and the scene still exists (if there were more than one device in it to start).
1. Press and hold SETUP until screen displays LGHT SETUP
2. Use either Arrow key to scroll until the display reads SCN SETUP
3. Press OK followed by either Arrow key until the display reads REMOVE
4. Press OK and the screen will display SEL DIGIT
5. Press a digit (1-9) for the scene you wish to remove the device from. Press SHIFT and the digit
(1-9) if you are removing devices from scenes 10 through 18.
6. Press the OK key and the screen will display SETUP WAITING
7. Press the button on the device that you wish to remove.
8. When the screen displays SUCCESS, you have successfully removed the device from the scene.
Deleting a Scene:
This only deletes the specific scene. All of the devices are still part of your home control network.
1. Press and hold SETUP until screen displays LGHT SETUP
2. Use either Arrow key to scroll until the display reads SCN SETUP
3. Press OK followed by either Arrow key until the display reads DELETE
4. Press OK and the screen will display SEL DIGIT
5. Press a digit (1-9) for the scene you wish to delete. Press SHIFT and the digit (1-9) if you are
deleting scenes 10 through 18.
6. The screen will display the selected Scene, press the OK key and the screen will display
SUCCESS.
LABELS
Individual LIGHTS, GROUPS and SCENES can all be labeled to help identify their function or location in
your home. The process is the same for all three.
1. Press and hold SETUP until the screen displays LGHT SETUP. Scroll to GROUP or SCENE if
changing those labels.
2. Press OK and the screen will read ADD
3. Use either Arrow key to scroll until the display reads LABEL
4. Press OK and screen will display SEL DIGIT
5. Press a digit (1-9) for the LIGHT, GROUP or SCENE you wish to rename. Press SHIFT and the
digit (1-9) if you are re-naming 10 through 18.
6. The screen will display the selected LIGHT, GROUP or SCENE
7. Use the #1 On/Off key to scroll through the alphabet/numbers until you reach the appropriate
letter or number
8. Use the right Arrow key to move to the next letter and repeat step 7
9. Continue this process until your new label is complete
10. Press the OK key and the screen will display SUCCESS.
ALL-ON and ALL-OFF Control
45633 Instructions rev 1-a.doc
Page 7 of 14
1/13/2010
Advertisement
Table of Contents
