Lubrication; Greasing The Traction Unit - Toro 22322 Operator's Manual

Figure 31
1. Nut
2. Oil cooler
7. Remove the front screen.
8. When finished, install the front screen with the 4 bolts
removed previously.
9. Install the oil cooler to the front screen with the 4
shoulder bolts and nuts removed previously.
10. Slide the sloped plate between the frame and the
weights and secure it to the front screen grill using the
carriage bolts and nuts removed previously
11. Tighten the bolts securing the front weights
12. Install the side screens and close the hood.
3. Front screen
4. Shoulder bolts
(Figure 29).
(Figure

Lubrication

Greasing the Traction Unit

Service Interval: Before each use or daily (Grease
Grease Type: General-purpose grease.
1. Lower the loader arms and shut off the engine.
Remove the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting
29).
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
27
immediately after every washing.)
(Figure
Figure 32
32).