Cases That Require Setting Changes - NEC N8100-2189F User Manual

Chapter 3 Setup
2.4

Cases that Require Setting Changes

Specify parameters according to the following table when your system matches "Description". The list of
SETUP parameters and factory settings are described in Chapter 2 (1. Details of System BIOS) in
"Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock on power ON
On/Off the function to display
the NEC logo during POST
Optional Install a
board
board
Memory Configure the memory after the
DIMM is added or exchanged.
Boot Change the boot order of
devices
Use remote power on feature
(from modem)
Use remote power on feature
(from RTC alarm)
Control from HW console
terminal
Security Set a password to restrict
operation of SETUP.
Set a password to restrict
booting.
UPS When the server is supplied
Powerlink with power from UPS, always
turn on the power.
If the server is turned off by
using POWER switch, leave it
OFF even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
Description
Main  System Date
Main  System Time
Boot  Bootup Numlock State
Boot  Quite Boot  Disabled
RAID controller
Advanced  PCI Configuration  PCI
Device Controller and Option ROM
Settings  PCI Slot n Option ROM 
Enabled
Advanced  Memory Configuration 
Memory Retest  Yes
Boot  Boot Option Priorities 
Change the boot priority
Advanced  Advanced Chipset
Configuration  Wake On Ring 
Enabled
Advanced  Advanced Chipset
Configuration  Wake On RTC Alarm
 Enabled
Advanced  Serial Port Configuration
 Change respective setting.
Security  Administrator Password 
Security  User password
Security  Password on Boot 
Enabled
Server  Power Control Configuration
 AC-LINK  Power On
Server  Power Control Configuration
 AC-LINK  Last State
Server  Power Control Configuration
 AC-LINK  Stay off
Express5800/T110g-E User's Guide
To be changed
Configurable on OS
By pressing <Esc> key, prevent
the display of the logo.
n is PCI slot number of the RAID
controller
After rebooting, the Memory
Retest setting changes to No
automatically.
After a password is set, the
entry of password is displayed
when SETUP is launched.
You can select this parameter
after you set a password.
2. System BIOS Setup
Remark
123