Inside-Reservoir Installation - Bosch Rexroth A10VO Instruction Manual

1 1)
SB
F
h
h
L
L
1
X
S
A10VO: For NG10 and NG28 Series 52, l
1)
A10VNO: For NG45 and NG63 Series 52, l
2) Only Series 53.
Fig. 7: A10VO below-reservoir installation with installation positions 1-4
Recommended installation position: 1 and 3.
Because complete air bleeding and filling are not possible in installation positions
2 and 4, the axial piston unit should be air bled and filled in a horizontal position
prior to installation.
2
SB
F
t min
min
L
1
L
S
is opposite, l must then be connected if necessary.
1
is opposite, l must then be connected if necessary.
1
Highest drain port
l, l , l
1 2
S Suction port
F Filling/air bleeding
Port F is part of the external piping and must be provided on the customer side
to make filling and air bleeding easier.
Table 8: Below-reservoir installation
Installation position
1 (drive shaft horizontal)
2 (drive shaft up)
3 (drive shaft horizontal)
4 (drive shaft down)
7.3.2

Inside-reservoir installation

Risk of damage with inside-reservoir installation!
To prevent damage to the axial piston unit, all plastic parts (e.g. protective plugs,
covers), except for the tamper-proof caps, must be removed prior to installation in
the reservoir.
▶ Remove all plastic parts, except for the tamper-proof caps, before you install the
axial piston unit in the reservoir. Make sure that no parts of them remain in the
reservoir.
▶ Remove the protective plug from the suction port S and open at least one
l port.
RE 92703-01-B/04.2018, A10VO, A10VSO, A10VNO, A10VSNO Series 52 and 53, Bosch Rexroth AG
3 2)
SB
F
h
t min
h
min
L
2
L L S
1
h
t min
h
min
SB
Air bleed
F
F
F
F
NOTICE
Installation
4
SB
h
h
t min t min
h
h
min
min
S
L
L
1
Min. required immersion depth
(200 mm)
Minimum required distance to
reservoir bottom (100 mm)
Baffle (baffle plate)
Filling
S + l or l
1
S + l
1
S + l
2
S + l or l
1
27/60
F