Installing and connecting the device
3.3 Connecting the device
3.2.5
Mounting the strain relief plate
Mount the strain relief plate included in the scope of delivery in the same way as described in
the "Unified Comfort Panels
(http://support.automation.siemens.com/WW/view/en/109795870)" operating instructions.
3.3
Connecting the device
The information in the "Unified Comfort Panels
(http://support.automation.siemens.com/WW/view/en/109795870)" operating instructions
applies to the connection of the device.
3.4
Removing the device
The HMI device is generally removed in the reverse order used for installing and connecting.
Procedure
Proceed as follows:
1. If a project is running on the HMI device, close the project with the HMI device configured
for this purpose. Wait until the Control Panel is displayed.
2. Switch off power to the HMI device.
3. When you use the HMI device in a hazardous area, make sure that one of the two following
requirements is met: The area is no longer hazardous or the device and its plug-in
connections are de-energized.
4. Remove all cable ties on the HMI device used for strain relief.
5. Remove all plug-in connectors and the equipotential bonding cable from the HMI device.
6. Secure the HMI device so that it cannot fall out of the mounting cutout.
7. Loosen the screws of the mounting clips and remove all mounting clips.
8. Remove the clamping frame.
9. Take the HMI device out of the mounting cutout.
See also
Connecting the device (Page 34)
Mounting the device with clamping frame and mounting clips (Page 32)
34
Unified Comfort Panels Hygienic
Compact Operating Instructions, 04/2023, A5E52219907-AA