Driving The Machine - Toro 30534N Operator's Manual

2. Make sure the traction pedal is in the neutral position.
3. Set the parking brake.
4. Move the PTO (power take off) switch to the off
position (Figure 11).
Figure 11
1. Power take off switch
(PTO)
2. Ignition switch
5. Move the throttle lever midway between the Fast and
Slow positions (Figure 11).
6. Turn the ignition key clockwise to the Run position
(Figure 12).
The glow plug light will turn on for 6 seconds.
Figure 12
1. Start
2. Run/glow plug
7. After the glow plug indicator light goes out, turn the
key to the Start position. When the engine starts
release the key.
Important: Use starting cycles of no more than
15 seconds per minute to avoid overheating the
starter motor.
3. Glow plug light
4. Throttle lever
3. Off
4. Glow plug indicator light
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been completely drained.
8. Leave the throttle midway between the Slow and Fast
positions until the engine and hydraulic system warm
up.
Important: When engine is started for the first
time, or after an engine oil change, or an overhaul
of the engine, transmission, or wheel motor,
operate the machine with the throttle lever in the
Slow position in both the forward and reverse
directions for one to two minutes. Also operate the
lift lever and PTO lever to ensure proper operation
of all parts. Then shut the engine off and check
fluid levels, check for oil leaks, loose parts, and
any other noticeable malfunctions.
CAUTION
Shut the engine off and wait for all moving
parts to stop before checking for oil leaks,
loose parts, or other malfunctions.
Stopping the Engine
1. Disengage the PTO, make sure the traction pedal is in
the neutral position, set the parking brake, and move
the throttle lever to the Slow position.
2. Let the engine idle for 60 seconds.
3. Turn the ignition key to the Off position (Figure 12).
Wait for all moving parts to stop before leaving the
operating position.
4. Remove the key before transporting or storing machine.
Important: Make sure to remove the key as the
fuel pump or accessories may run and cause the
battery to lose charge.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.

Driving the Machine

The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Place the throttle control in
the Fast position for best performance. Always operate in the
Fast throttle position when mowing.
21