Table of Contents
Advertisement
Figure 137
1. Washer
3.
Remove the cabin roof of the cab by removing
the 22 bolts that secure the roof
Figure 138
1. Cabin roof
2. Air filters
4.
Remove the air filters
5.
Remove and clean the air-conditioning coils
(Figure
138).
6.
Replace the air-conditioning coils, air filters and
cabin roof.
g028380
2. Nut
(Figure
138).
g028378
3. Air-conditioning coils
(Figure
138).
Storage
Storage Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
Preparing the Machine for
Storage
Important:
Do not use brackish or reclaimed
water to clean the machine.
Preparing the Traction Unit
1.
Thoroughly clean the traction unit, cutting units,
and engine.
2.
Check the tire pressure. Inflate all traction unit
tires to 83 to 103 kPa (12 to 15 psi).
3.
Check all fasteners for looseness and tighten
them as necessary.
4.
Grease all grease fittings and pivot points. Wipe
up any excess lubricant.
5.
Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
6.
Service the battery and cables as follows:
A.
Remove the battery terminals from the
battery posts.
Note:
Always disconnect the negative
terminal first and the positive last. Always
connect the positive terminal first and the
negative last.
B.
Clean the battery, terminals, and posts with
a wire brush and baking soda solution.
C.
Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Part
Number 505-47) or petroleum jelly to
prevent corrosion.
D.
Slowly recharge the battery every 60 days
for 24 hours to prevent lead sulfation of the
battery.
Preparing the Engine
1.
Drain the engine oil from the oil pan and replace
the drain plug.
91
Advertisement
Table of Contents
