Husqvarna 236R Operator's Manual page 13

a) Make sure that you operate the socket wrench in
the identified area when you loosen or tighten the
saw blade nut.
To attach a blade guard, grass blade and
grass cutter
CAUTION: Make sure that the guard
extension is removed.
Note: Use the recommended blade guard. Refer to
Accessories on page 27 .
1. Install the blade guard to the shaft. Attach the blade
guard with the bolt (L).
L
A
2. Attach the drive disc (B) to the output shaft.
3. Turn the output shaft until 1 of the holes in the drive
disc aligns with the hole in the gear housing.
1395 - 004 - 14.09.2020
4. Put the locking pin or hex key (C) into the hole to
5. Put the blade (D), support flange (E) and support
6. Install the nut (G). Use the combination wrench and
7. To tighten the nut, turn the combination wrench in
To attach the trimmer guard and the trimmer
head
Note: Make sure to use the correct trimmer guard for the
correct trimmer head.
1. Attach the correct trimmer guard/combination guard
2. Hang the trimmer guard/combination guard (A) on
3. Install the trimmer guard/combination guard around
G
F
E
D
A
B
4. Put the locking pin or hex key (C) in the groove on
C
5. Attach the drive disc (B) on the output shaft.
6. Turn the output shaft until one of the holes in the
lock the shaft.
cup (F) on the output shaft.
tighten the nut to torque 35-50 Nm. Hold the shaft of
the combination wrench as near the blade guard as
possible.
the opposite direction to the direction of rotation.
Note: Left hand thread.
(A) for the trimmer head.
the 2 hooks on the plate holder (M).
the shaft and tighten it with the bolt (L). Use the
locking pin or hex key (C).
H
L
M
C
A
the screw head and tighten.
drive disc aligns with the hole in the gear housing.
A
B
M
L
13