Table of Contents
Advertisement
Introduction
The Avigilon ACC ES Analytics Appliance is an all-in-one solution for network video recording plus server
side video analytics. The appliance features:
A network switch to connect and power IP cameras.
l
Built-in server to run the Avigilon Control Center Server Software.
l
Video analytics engine to enable connected cameras to detect classified objects.
l
This guide describes how to configure the system after the appliance has been powered and is connected
the local area network.
Before You Start
Avigilon recommends the use of an uninterruptible power supply (UPS) system to protect your video
surveillance system hardware. A UPS system is used to protect critical equipment from mains supply
problems, including spikes, voltage dips, fluctuations and complete power failures using a dedicated
battery. It can also be used to power equipment during the time it takes for a standby generator to be
started and synchronized.
Any UPS connection must include configuration to shut down the operating system on the appliance when
battery power is low or there is 15 minutes of power remaining.
It is recommended that cameras not be connected to the appliance until after the appropriate network
configuration has been set up.
Package Contents
Ensure the package contains the following:
Avigilon Video Appliance
l
Power cord
l
Power supply and screwdriver to secure it
l
Wall installation hardware
l
Digital input/output terminal block connector
l
Introduction
1
Advertisement
Table of Contents
