Maintenance - Husqvarna AUTOMOWER 320 NERA Operator's Manual

38.3.1.3 Select duration
The product goes back to the charging station and
stays for the selected park duration. Use the operation
selection to temporary stop an ongoing mowing cycle
and let the product to stay in the charging station.
38.3.1.4 Park at maintenance point (EPOS
only)
You can park the product at the maintenance point to do
maintenance on the product. The product is parked at
the maintenance point until you select a new operation
mode.
38.4 To stop the product
1. Push the STOP button to make the product and
the cutting motor stop.
38.5 To set the product to OFF
1. Push the STOP button to stop the product.
39.1 Introduction
Speak to an authorized service center for full
maintenance and service of your product.
WARNING:
safety chapter before you use the product.
39.2 Cleaning
For better operation and longer service life, make sure
to clean the product regularly and replace worn parts.
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass. Clean the product
with a brush or running water from a water hose.
We recommend you to use a special cleaning and
maintenance kit. Speak to your local Husqvarna
representative for more information.
CAUTION:
Do not use a high-pressure
washer to clean the product. Do not use
solvents to clean the product.
39.3 Battery
CAUTION:
Charge the battery fully
before you put the product into storage. If
the battery is not fully charged it can cause
damage to the battery.
If the operating time of the product is shorter than usual
between charges, this means that the battery is at the

102 - Maintenance

™ installation
39 Maintenance
Read and understand the
2. Enter the PIN code if it is necessary.
3. Push the jog wheel for 3 seconds to set the
product to OFF. You can also use the jog wheel
Power off in the menu in the display.
to select
4. Make sure that the LED indicator on the jog wheel
is not lit.
38.6 To charge the battery
When the product is new or after long-term storage, the
battery can be empty. Charge the battery before you
Main area mode, the product
start the product. In the
cuts and charges automatically.
1. Set the product to ON.
2. Put the product into the charging station until the
charging plates touch the contact plates.
3. Do a check that the product charges in the display
of the product or in the Automower
end of its life cycle. Replace the battery to extend the
operating time.
Note:
The battery life is related to the length of
the season and how many hours a day the product
operates. A long season or many hours of operation
a day means that the battery must be replaced more
regularly.
39.4 Replacement of the blades
WARNING:
guarantee safety if you use Husqvarna
original blades with the embossed crowned
H-mark logotype.
WARNING:
screws when you replace the blades. The
used screws can wear quickly and make the
blade come loose, this can cause serious
injury.
Replace worn or damaged blades for a safe operation.
Replace the blades regularly for a satisfactory cut result
®
Connect app.
Husqvarna can only
You must replace the
1910 - 002 - 03.01.2023