To Put The Wire Into Position With Stakes - Husqvarna AUTOMOWER 420 Operator's Manual
Hide thumbs
Also See for AUTOMOWER 420:
- Technical manual (104 pages) ,
- Operator's manual (100 pages) ,
- Workshop manual (60 pages)
Table of Contents
Advertisement
2.
Open the connector and put the boundary wire in
the connector.
3.
Close the connector with a pair of pliers.
4.
Cut the boundary wire 1-2 cm / 0.4-0.8 in. above
each connector.
5.
Push the right connector onto the metal pin on the
charging station with the mark "AR".
6.
Push the left connector onto the metal pin on the
charging station with the mark "AL".
3.5.4 To install the guide wire
CAUTION:
screw terminal block that is insulated with
insulation tape are not satisfactory splices.
Soil moisture will cause the wire to oxidize
and after a time result in a broken circuit.
1.
Open the connector and put the wires in the
connector.
2.
Close the connector with a pair of pliers.
3.
Cut the guide wires 1-2 cm / 0.4-0.8 in. above each
connector.
4.
Put the guide wires centrally below the charging
station plate, and push them through the slot in the
charging station tower.
5.
Push the connector onto the metal pin on the
charging station with the mark "G1, G2" or "G3".
6.
Disconnect the charging station from the power
outlet.
7.
Put the cable mark on the guide wires.
8.
Put the end of the guide wires at the eyelet on the
boundary wire.
9.
Cut the boundary wire with a pair of wire cutters.
10. Connect the guide wires to the boundary wire with
a coupler.
20 - Installation
Twinned cables, or a
a)
Put the 2 ends of the boundary wire and the
end of the guide wires into the coupler.
Note:
Make sure that you can see the end
of the guide wires through the transparent
area of the coupler.
b)
Push down the cover on the coupler with
adjustable pliers to attach the wires in the
coupler.
11. Attach the guide wires to the ground with stakes
or bury the guide wires in the ground. Refer to
put the wire into position with stakes on page 20
To bury the boundary wire or the guide wire on
or
page 21 .
12. Connect the charging station to the power outlet.
3.6 To put the wire into position with
stakes
CAUTION:
hold the boundary wire and the guide wire
against the ground.
Make sure that the stakes
1201 - 007 - 20.02.2023
To
Advertisement
Table of Contents
