Basic Adjustment Items - Canon Inner Finisher-L1 Service Manual

Items
To set whether to suspend deliv-
ery when it is detected that the Fin-
isher Tray is full
To set whether to stop the ma-
chine when an error occurs at Fin-
isher
To set the duration of time before
executing automatic stapling at
manual staple mode
To set the staple position of staple
free stapling
To set the staple-free stapling
without staple cartridge
To set the duration of time to keep
manual staple mode enabled after
execution of manual stapling
To set the tray position after the
completion of job
To set the start timing of paper re-
tainer operation
Set assist guide operation start
timing
Switching the high-productivity
punch mode or high-accuracy
punch mode of the inner puncher
unit
To set whether to perform the hor-
izontal registration operation of the
inner puncher unit for matching
with the center of the paper
To set the punch hole specification
of the inner puncher unit

Basic Adjustment Items

No Items
Adjusting the Alignment Posi-
1
tion at Staple Mode
Adjusting the Alignment Posi-
2
tion at Non-staple Mode
Adjusting the Adjusting the Return Belt
3
Alignment Pressure
Adjusting Center Alignment
4
Standard Position
Right Angle Adjustment of
5
Alignment Plate
Adjusting the
6 Adjusting the Staple Position
Staple Position
Service Mode
(SORTER> OP-
TION)
TRY-STP Upon user's request
MD-SPRTN When preferring to run the machine although an
error occurs at Finisher
MSTP-TMG Upon user's request
FR-ST-PO Upon user's request
FR-ST-SW Upon user's request
MSTP-WT Upon user's request
TRY-PSTN Upon user's request (to improve visibility of the
delivered paper)
RET-TMG When a paper stack is discharged to a position
that cannot be reached by the paper retainer and
stacking failure occurs due to the paper stack be-
ing pushed out by the next paper stack.
ASTG-TMG When the stack delivery failure occurs.
PUCH-SW When switching the high-productivity punch mode
or high-accuracy punch mode.
PUN-Y-SW When the adjustable range of the punch hole hor-
izontal registration adjustment is enlarged.
PNCH-SW2 When replacing the Puncher Controller PCB.
When the paper alignment position is displaced in the
staple mode or staple-free staple mode.
When the paper stacking position is displaced in the non-
sort mode or shift-sort mode.
When misalignment occurs in feed direction.
• When the standard position for the center alignment
is misaligned.
• When misalignment occurs in front/ rear direction.
• When remove or replace the Alignment Plate.
• When the paper alignment position is displaced.
When the staple position in front/rear direction is dis-
placed in the front/rear 1-stapling mode or 2-stapling
mode.
Use case
Use case
98
5. Adjustment
Remarks
This mode is available when
the inner puncher unit has
been installed.
Refer to
"Adjusting the Alignment
Position at Staple Mode"
on page 101
"Adjusting the Alignment
Position at Non-staple
Mode" on page 102
"Adjusting the Return
Belt Pressure" on page
102
"Adjusting Center Align-
ment Standard Position"
on page 103
"Right Angle Adjustment
of Alignment Plate " on
page 104
"Adjusting the Staple
Position " on page 108