Table of Contents
Advertisement
Customer Care Europe, Middle East & Africa
SCCE Training Group
Flowchart - No service → no TX
Set Phone to TX -Mode
EGSM 897.4 MHz,
Ch. 37, power level 10.
Set Spectrum Analyzer to
TX EGSM 897.4 MHz, Ch.37.
Check TX
EGSM 897,4 MHz
at R656.
© NMP 2003
No Service/
No TX EGSM/PCN.
Set Phone to TX -Mode
Ch.700, power level 10.
Set Spectrum Analyzer to
PCN 1747.8 MHz, CH. 700.
OK
nOK
nOK
Check TX I/Q
67.71 kHz signal at
C764 and C766 at
both sides.
OK
Check
TXP VDC > 1.8 V
at C760 with
oscilloscope.
OK
Check TXC
signal at C761
with oscilloscope.
OK
Check 26 MHz
at C752.
OK
Check the
following voltages:
VR2 = 2.8 VDC at C294; VR3 = 2.8 VDC at
C602; VR4 = 2.8 VDC at C601;
VR5 = 2.8 VDC at C604; VR6 = 2.8 VDC at
C605; VR7 = 2.8 VDC at C299;
VrefRF01 & VrefRF02 = 1.35 VDC at R726;
VR1A = 4.7 V at R600.
OK
Hagar N600
defective.
CONFIDENTIAL
NPE-4 6310/NPL-1 6310i
Date 22.04.2003
PCN 1747.8 MHz,
Check TX
PCN 1747.8 MHz
OK
at L602.
nOK
nOK
nOK
nOK
nOK
Checked by:
SCCE Training Group
Repair Hints
Version 3.0 Approved
Check TX EGSM/PCN path from
Hagar to X802 antenna connector
for shorts or disconnections.
Probably N840 defective.
Check UEM D200.
Check UPP
D400.
Check UEM D200.
Check 26 MHz
circuit, especially
G740.
Check UEM D200.
Approved by:
SCCE
19 (29)
Advertisement
Table of Contents
