Table of Contents
Advertisement
Removing the Existing
Recycling Baffles from the
Cutting Unit
DANGER
If you raise the machine using only a jack to
support it while you work under the mower
deck, the jack could tip, causing the mower
deck to fall, crushing you or bystanders.
Always secure the machine with at least 2 jack
stands when you have the mower deck raised.
Note:
This procedure is not required on models
shipped without the cutting unit baffles installed.
1.
Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2.
Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the nut, bolt, and spacer securing the
deck roller to the mounting bracket, and remove
the deck roller
(Figure
4.
Remove the carriage bolts and nuts securing the
roller-mounting bracket to the underside of the
mower deck, and remove the roller-mounting
bracket
(Figure
1).
5.
Remove the carriage bolts and nuts securing the
center, left, and right baffles to the underside of
the mower deck, and remove the baffles
1).
-
position and
LOCKED
position,
LOW
1).
(Figure
62-inch mower deck shown
1. Deck roller
2. Roller-mounting bracket
3
Figure 1
3. Baffle
g014976
Advertisement
Table of Contents
