Pioneer PRO-1000HDI Service Manual page 150

1
GSD
(Get Shut Down)
A
• The acquired data are output according to the transmission order and size in the table below.
• This command is valid only in RS-232C Factory Adjustment mode and during shut down (for 30 seconds until a shutdown occurs or standby).
Note: During power-down, data can be obtained by directly executing "GPD" without executing "FAY." However, the ID must be set
beforehand.
Table 1: GSD
Order
1 The latest "SD INFO"
2 First latest "SD INFO"
3 Second latest "SD INFO"
4 Third latest "SD INFO"
B
5 Fourth latest "SD INFO"
6 Fifth latest "SD INFO"
7 Sixth latest "SD INFO"
8 Seventh latest "SD INFO"
(Note 1) See the table below on SD information
Table 2: SD contents
GET Data
1 Panel microcomputer communication failure
C
2 Module IIC communication failure
3 Condensation
4 Temperature abnormality
5 FAN abnormality
6 Module microcomputer communication failure
7 Wide microcomputer communication failure
8 Main IIC communication failure
9 AUDIO failure
D
E
F
150
1
2
: O
utputting TxD data on SD (Shut Down) INFORMATION of
Service Factory MENU
Data Contents
Shut Down Point
PRO-1000HDI
2
3
Size Remarks
1 byte (Note 1)
1 byte (Note 1)
1 byte (Note 1)
1 byte (Note 1)
1 byte (Note 1)
1 byte (Note 1)
1 byte (Note 1)
1 byte (Note 1)
3
4
4