Table of Contents
Advertisement
4.10.7.4
Setting Backlight
When and where to use: To save the battery power.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Display→Backlight.
3 Select one of the following options:
•
Auto – Backlight is triggered by turning on the radio, by pressing any key on the device or
on the accessory that is connected to it. Also charging or getting signal from the services
like: Call-Out message, RUA request, DGNA, TX timeout during priority call, and new SDS
messages are going to turn on the backlight.
•
Semi Auto – Backlight is turned on when you are switching on the radio, pressing assigned
button to the backlight feature, or charging.
•
Disabled – backlight is disabled and the display is always dimmed.
4.10.7.5
Setting Brightness
When and where to use: To set the luminance of the display and the keypad in an environment with
low visibility.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Display→Brightness.
3 Select one of the following options:
•
Level – Allows you to manually set the brightness level using the Left or Right Navigation
key.
•
Automatic – Enables or disables the automatic brightness mode, in which the radio uses
a photo sensor to automatically adjusts brightness to the ambient light. However, it is still
possible to adjust brightness using the Left or Right Navigation key in the Level menu.
4.10.7.6
Setting LCD Off
When and where to use: This feature sets the time so the display automatically turns off after a
specific amount of time.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Display→LCD Off.
3 Select one of the following options:
•
Disabled – Your radio display never goes off.
•
30 seconds – Turns off the radio display after 30 seconds.
•
1 minute – Turns off the radio display after 1 minute.
•
2 minutes – Turns off the radio display after 2 minutes.
•
5 minutes – Turns off the radio display after 5 minutes.
MN006260A01-AG
Chapter 4 : Main Menu
121
Advertisement
Table of Contents
