Honeywell EK205-M Operating Instructions Manual page 44

44
◼ Change the value using the arrow buttons  or . In doing so, observe the legal
provisions applicable at the place of use.
Md.K
Fixed value
S-Gerg-88
AGA-NX19
AGA-8 GC1
AGA-8 GC2
AGA-NX19-HW
AGA-8 DC92
Press the ENTER  +  button to confirm the set value. It is possible to abort the entry
◼
by pressing the key combination ESC  + .
◼ Move the cursor with the arrow keys  or  further to the gas analysis values
CO2, etc.).
◼ Change the values in accordance with the gas used by enabling with the ENTER  + 
key combination the entry, going with the arrow keys  or  to the figures and changing
them with the keys  or .
◼ Press the ENTER  +  button to confirm the set value. It is possible to abort the entry
by pressing the key combination ESC  + .
The calorific value Ho,b applies to the basic conditions pbX, TbX and
reference combustion temperature +25°C. pbX and TbX are adjustable under
calibration lock.
6.3.1.8 Setting the alarm limits for gas pressure and temperature measurement
Ex works, the alarm thresholds are set to sensible values. If a change is necessary, proceed as
follows:
◼
Move the cursor to the "Serv" tab and via the following paths to the alarm thresholds:

Serv. Measured values

Serv. Measured values
Press the key combination ENTER  +  to enable the entry.
◼
◼ Move the cursor with the arrow buttons  or  to the digits and change these with the
arrow buttons  or .
Press the ENTER  +  button to confirm the set value. It is possible to abort the entry
◼
by pressing the key combination ESC  + .
8
These values are not required in the performance as Temperature Conversion device.
Meaning
No calculation of the compressibility. The adjustable K.F value is
used.
Calculation of the compressibility in accordance with S-Gerg-88
Calculation of the compressibility in accordance with AGA-NX19
AGA8 gross characterization method 1
AGA8 gross characterization method 2
AGA-NX19 according to Herning and Wolowsky
AGA8 detailed characterization

Pressure

Temperature
Installation, connection and commissioning

8
pMin and pMax

TMin and TMax
(Ho.b,