Panasonic EU6441-U1 Service Manual page 14

EU6441-U1
b. Align the Wires so that the Power source wire and the
Sensor wire are parallel. Bind the two Wires on the
partapprox. 50-60mm(2-2 3/8´´) from the Wire fixing part
(A) with the Insulated tie small.
* Bind the Wires along the Power source wire so that
the Wires are not tangled.
2. Align the Wires.(1)
a. Pass the Insulated tie middle through the Plastic cover,
and fix the Power source wire, Sensor wire, and other
Wires in order. Bind and fix them in 1 cm(3/8´´) from the
marking (black tape) on the Power source wire.
b. Hook the bound/fixed Power source wire and the Driving
motor wire on the A part of the PCB case. Set the
Sensor wire beneath the PCB case.
14