LG Studio WashTower WK X30 H A Series Installation Manual page 29

en-us_main.book.book Page 29 Monday, January 16, 2023 3:17 PM
Error
Possible Cause & Solution
Messages
Humidity Humidity sensor failure.
Sensor
• Turn off the appliance and call for
Error
service.
Electric dryer power cord is not
Power
Supply / connected correctly, or house
High power supply is incorrect.
Voltage /
• Reset circuit breaker or replace
Low
fuse. Do not increase the fuse
Voltage
capacity.
House fuse is blown, circuit
breaker has tripped, or power
outage has occurred.
• If the problem is a circuit
overload, have it corrected by a
qualified electrician.
Gas Gas supply or service turned off.
Supply (Gas Model only.)
• Confirm that house gas shutoff
and the dryer gas shutoff are
both fully open.
Duct Exhaust system is too long or has
Blockage too many turns/restrictions.
(80%) /
• Do not use the appliance until
Duct
the exhaust system has been
Blockage
cleaned and/or repaired. Using
(90%) /
the appliance with severely
Duct
restricted exhaust is dangerous
Blockage
and could result in a fire or other
(95%)
property damage.
• Check the outside dryer vent
while the appliance is operating
to make sure there is strong
airflow. If the exhaust system is
extremely long, have it repaired
or rerouted.
Door Door open error.
Open
• Do not open the door when
doing installation mode. Restart
Installation mode.
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed transition duct
Too many elbows or exhaust too long
Check for blockages and lint buildup.
INSTALLATION 29