VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before beginning the installation and use of this appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
GENERAL SAFETY This appliance is for washing domestic-type, machine-washable • laundry only. This appliance is designed for single household domestic use • in an indoor environment. This appliance may be used in, offices, hotel guest rooms, bed • & breakfast guest rooms, farm guest houses and other similar accommodation where such use does not exceed (average) domestic usage levels.
SAFETY INSTRUCTIONS INSTALLATION • Make sure not to cause damage to the mains plug and to the mains cable. Should the mains The installation must comply with cable need to be replaced, this must be carried relevant national regulations. out by our Authorised Service Centre. •...
• Do not touch the glass door while a programme professional repairers, and that not all spare operates. The glass can get hot. parts are relevant for all models. • Make sure that all metal objects are removed • Concerning the lamp(s) inside this product and from the laundry.
Control panel Inlet hose connection Door handle Mains cable Rating plate Transit bolts Feet for levelling the appliance Hose support Drain hose The rating plate reports the model name (A) , product number (B), electrical ratings (C) and serial number (D). Mod.
UNPACKING WARNING! It is possible to see water flowing from the drain hose. 1. Open the door. Remove all the items from the This is because the washing drum. machine has been tested at the factory. 4. Remove the three transit bolts and pull out the plastic spacers.
Page 8
CAUTION! Make sure there is no damage to hoses and there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Contact the service centre for a replacement inlet hose. 1. Connect the water inlet hose to the back of the 2.
INSTALLATION ON SUSPENDED FLOORING Suspended wooden floors are particularly susceptible to vibration. To limit vibration we recommend placing a The end of the drain hose must always waterproof wooden panel, at least 15 mm thick, be ventilated , i.e. the inner diameter of under the appliance.
FIXING PLATE KIT If you install the appliance on a plinth that is not an accessory supplied by ZANUSSI, secure the appliance in the fixing plates. Read carefully the instructions supplied with the accessory.
Door locked indicator. Delay start indicator. The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. • Cycle end ( • Warning code (e.g. FlexiTime bars level indicator. Drum clean indicator. Child safety lock indicator. Add garments indicator.
regularly to reduce creasing. You must drain the The display shows the indicator and the water to unlock the door. selected delay time. After touching the Start/Pause As the programme is very quiet, it is suitable for button, the appliance begins the countdown use at night time when cheaper electricity tariffs and the door is locked.
PROGRAMMES PROGRAMME CHART Reference spin Programme speed Programme description Default temperature Maximum load Spin speed (Type of load and level of soiling) Temperature range range Eco 40-60 1400 rpm 9 kg White cotton and fast-coloured cotton. (1400- 800 Normally soiled items. The energy consump- 40 °C rpm) tion decreases and the time of the washing...
Page 15
Reference spin Programme speed Programme description Default temperature Maximum load Spin speed (Type of load and level of soiling) Temperature range range 1400 rpm 9 kg White cotton items. This programme removes CleanBoost (1400- 800 micro-organisms thanks to a washing phase 60 °C rpm) with the temperature maintained above 60°C...
Liquid for col- Delicates Programme Liquid Universal Special Universal powder oureds woollens ▲ ▲ 14min Refresh ▲ ▲ 30min Rapid ▲ ▲ ▲ 60min EasyWash 1) At temperature higher than 60 °C the use of powder detergent is recommended. ▲ = Recommended -- = Not recommended SETTINGS ACOUSTIC SIGNALS...
3. Put the laundry in the drum, one item at a time. CAUTION! Make sure that no laundry Do not put too much laundry in the drum. gets caught between the seal and the 4. Close the door firmly. door to avoid risk of water leakage and damage to the laundry.
The indicator of the Start/Pause button flashes. The display shows an indicative programme duration. 2. To change the temperature and/or the spin speed, touch the related buttons. 3. If desired, set one or more options by touching the related buttons. The related indicators illuminate on the display and the given information changes accordingly.
2. Press the button ON/OFF again to activate the 3. Touch the Delay Start button repeatedly appliance. until the display shows and the indicator If the AutoAdjust System has goes off. completed and the water filling has 4. Touch the Start/Pause button again to start already started, the new programme the programme immediately.
• If you have set Rinse Hold The door unlocks and the indicator goes off. appliance drains the water and spins. 1. Press button ON/OFF to deactivate the appliance. • If you have set Night the appliance only drains the water After five minutes from the end of the programme, the energy saving function automatically The option indicator Rinse Hold...
• Do not wash laundry without hems or with cuts. • Follow the instructions that you find on Use a washing bag to wash small and/or packaging of the detergents or other treatments delicate items (e.g. underwired bras, belts, without exceeding the indicated maximum level tights, shoelaces, ribbons, etc.
Page 23
Use the correct quantity of water softener. Follow the instructions that you find on the packaging of the product. ALARM CODES AND POSSIBLE FAILURES The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the tables).
Page 24
Problem Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed. • Make sure that there is no damaged fuse in the fuse box. The programme does •...
Problem Possible solution After the washing cycle, • Make sure that the flap is in the correct position (UP for powder deter- there are some deter- gent - DOWN for liquid detergent). gent residues in the dis- • Make sure you have used the detergent dispenser according the indi- penser drawer.
the inner part of the appliance, run a maintenance Occasionally, at the end of a cycle the wash regularly (at least once a month). display may show the icon : this is a recommendation to perform the “drum Refer to "Cleaning the drum" cleaning”.
4. Insert the detergent drawer into the guide rails and close it. Run the rinsing programme without any clothes in the drum. CLEANING THE INLET HOSE AND THE VALVE FILTER 45° 20° EMERGENCY DRAIN 1. Disconnect the mains plug from the mains socket.
WARNING! Make sure that the temperature is higher than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. CONSUMPTION VALUES INTRODUCTION See the web link www.theenergylabel.eu for detailed informa- tion about Energy Label. For Non EU The QR code on the energy label supplied with the appliance pro- vides a web link to the product information sheet.
Eco 40-60 pro- Litres hh:mm °C gramme Quarter load 0.442 39.0 2:35 54.00 26.0 1351 1) Maximum spin speed. Power consumption in different modes Off (W) Stand-by (W) Delay start (W) 0.50 0.50 4.00 Time to Off/Standby mode is 15 minutes maximum. COMMON PROGRAMMES These values are indicative only.
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it. Help contact your municipal office. protect the environment and human health by recycling waste of electrical and electronic appliances.