Chapter 6. DSLT Features
To transfer a call using OHVA:
1. While on a call, press the HOLD key.
2. Dial the extension number to which the call is being trans-
ferred.
3. Enter OHVA feature access code (default = 8) and
announce the call to be transferred.
4. If transfer is: not accepted, press the FLASH key.
5. Replace the handset.
Hardware Requirements
•
N/A
Related Programming
•
FF1 0 03 (System): Extension COS OHVA Originate
•
FF1 0 03 (System): Extension COS OHVA Receive
•
FF3 (Extension): Extension COS Assignments
•
FF4: FF Key Assignments
Considerations
•
If Onhook Transfer is enabled, the held call is transferred as soon as the extension sending the
OHVA hangs up.
•
If the transferred call is not answered immediately, it will queue for a set time limit, then return
to the extension sending the OHVA by Transfer Recall Timer.
•
You cannot receive a Call Waiting message during an OHVA.
•
If you make an OHVA to an SLT, the SLT user and the other party will hear the announcement.
Onhook Dialing
Description
Onhook Dialing allows users to dial without lifting the handset. However, the Digital Single Line
Telephone (DSLT) does not have a microphone so you must lift the handset to talk.
Operation
To use onhook dialing:
1. Press the ON/OFF key.
2. Enter a trunk access code, or dial an extension number.
6-38
Action
Action
DBS 576 (USA) issued September 2001
Section 700 - Operation
Result
Current call on hold
Busy signal
Transfer canceled
Result
Intercom dial tone
576-50-700