Sharp IG-GC2B Operation Manual page 23

Plasmacluster Ion Generating Unit (Electrode section)
Every 6 months or more often if necessary
1
Remove dusts from the electrodes by the unit cleaning brush (see E-4).
2
Connection
Terminal
Reattach the unit holder, unit cleaning brush, main unit cover and fi lter
3
cover.
Please wire the power cord correctly.
Incorrect wiring could lead to damage to the power cord and may cause
fi re/electric shock.
③
①
②
Micro USB Plug
Note
• Do not clean with anything other than the unit cleaning brush. (Doing so could lead to
failures in the unit)
• A bent electrode could be cut off and dropped during the cleaning process, but it will
not change the performance.
• Do not touch the electrode directly. (Doing so could lead to pain/itching)
• Do not deform the electrodes. (Doing so could lead to failures in the unit)
• Do not touch the connection terminal. (Doing so could lead to failures in the unit)
IG-GC2_EN(TH).indd 9 IG-GC2_EN(TH).indd 9
Main Unit
Cover
Unit Holder
Electrode
④
E-9
How to remove the unit holder
1 Remove the fi lter cover. (see E-8)
2 Pull up the main unit cover.
3 Pull out the unit holder.
Electrode
Before Cleaning
Insert the Micro USB Plug for connection
with main unit to the power supply port 1.
Put the power cord on 2 and 3.
Insert the power cord into the claw of 4
When attaching the main unit cover,
put the power cord through the hole
on the main unit cover.
After Cleaning
6/13/2559 BE 9:14 AM 6/13/2559 BE 9:14 AM