• 1 x hex wrench • 2 x 31.75 mm / 1.25 in. wall plugs • 2 x 31.75 mm / 1.25 in. screws • 1 x lens mask • 2 x additional curtain shutters • 1 x tamper cup •...
The detection LED (blue) flashes three times. Alternatively, you can remove the jumpers and connect a discrete resistor directly to the alarm or tamper outputs, as specified by Wait approximately 2 to 3 minutes to allow the detector to third-party equipment. settle.
DI601 / DDI602 includes magnetically immune, volt-free relay Configuration Height Tilt (°) Max. range Reference contacts that can be used to trigger alarm inputs on connected (m / ft.) (m / ft.) equipment. Pet immunity [1] 1.5 / 5 −2 30 / 98 Figure 11 The contacts are rated at a maximum of 24 V AC/DC at 50 mA.
7/0.2 mm² / 24 AWG Accessories Cable < 500 m / 1640 ft. Utilising all three outputs (including tamper) — GE Security can provide a handheld walk tester DI601-WT to aid eight-core 16/0.2 mm² / 20 AWG installations. Regulatory information...
2004/108/EC (EMC directive): Non-European manufacturers must designate an authorized representative in the Community. Our authorized manufacturing representative is: GE Security B.V., Kelvinstraat 7, 6003 DH Weert, The Netherlands. Usage restrictions Only use the listed models in the following countries:...