Table of Contents
Advertisement
global_main.book.book Page 21 Friday, February 24, 2023 1:51 PM
Burners
• Remove the burner lids and flame spreaders by
pulling them upwards and away from the top
plate.
• Soak them in hot water and a little detergent or
washing up liquid.
• After cleaning and washing them, wipe and dry
them carefully. Make sure that the flame holes
are clean and completely dry.
• Wipe the fixed parts of the burner cup with a
damp cloth and dry afterwards.
• Gently wipe the ignition device and flame
supervision device with a well wrung-out cloth
and wipe dry with a clean cloth.
• Before placing the burners back on the top plate,
make sure that the injector is not blocked.
Reassemble the Auxiliary, Semi-Rapid, Rapid
and Triple-Crown Burners as follows:
1
Place the flame spreader
cup
so that the ignition device and the flame
e
supervision device extend through their
respective holes in the flame spreader. The
flame spreader must click into place correctly.
2
Position the burner lids (
flame speader
so that the retaining pins fit
d
into their respective recesses.
• Replace parts in the correct order after cleaning.
onto the burner
d
,
,
) onto the
a
b
c
MAINTENANCE
CAUTION
- Do not mix up the top and bottom.
- The locating pins must fit exactly into the
notches.
21
Advertisement
Table of Contents
