To start the program, read the general Terms and Conditions, then click on the Accept and
Start button. In order to read out the modules firmware, MAC address, serial number, radio
version, bootloader version and hardware revision, perform the following steps:
1. On the top, choose the corresponding COM port. It is the same as used in
Wired – Connecting through USB0 and a Terminal
2. Click the Connect button.
3. Lastly click on the Read Out button.
4. You should see a response in the Communication part of the GUI:
Quick Start Guide Rev. 1.0
Figure 12: WIFIgurator connection
Figure 13: WIFIgurator Reading Info
PAN9420 Quick Start Guide
Program.
4.2.1
Page 19