Husqvarna CT 36A/A-V Operator's Manual page 13

Note:
Do not twist the starter rope around your
hand.
6. Continue pull the starter rope handle until the engine
starts.
CAUTION:
rope to full extension and do not let go
of the starter rope handle. Release the
starter rope slowly. If you do not obey
these instructions it can cause damage
to the engine.
7. Open the choke control gradually until it is fully open.
8. Let the engine operate at idle speed for 2–3 minutes.
9. Hold the product securely at the handle with two
hands. Move the throttle control to increase the
engine speed, but do not release the handle.
To adjust the blade pitch
The blade pitch is adjusted gradually.
• For products with a blade pitch knob (A):
A
1452 - 003 - 30.01.2023
Do not pull the starter
a) To increase the blade pitch, turn the blade pitch
knob clockwise.
b) To decrease the blade pitch, turn the blade pitch
knob counterclockwise.
• For products with a Pro-Shift
B
a) To increase the blade pitch, pull the Pro-Shift
lever up in the direction of the handle.
b) To decrease the blade pitch, push the Pro-Shift
lever down.
Working techniques
The floating operation removes dents on the concrete
surface. The concrete surface must be sufficiently hard
before the floating operation. The concrete surface is
sufficiently hard when a shoe gives not more than 3 mm/
0.12 in. deep recess on the concrete surface.
When the floating operation is completed, the concrete
surface is prepared for the troweling operation. The
troweling operation increases the density of the concrete
surface and makes it smooth and hard.
CAUTION:
concrete surface during operation. Loose
stones can make marks that are not easy
to remove from the concrete surface.
To do the floating operation
1. Set the throttle control to an applicable speed.
CAUTION:
high. Too high speed on wet concrete
can cause damage to the surface. Adjust
the speed during the operation as the
concrete becomes harder.
2. Adjust the blade pitch until there is tension in the
blade pitch cable. Refer to
on page 13 .
®
lever (B):
Look for loose stones on the
Do not set the speed too
To adjust the blade pitch
®
®
13