Epson ActionDesk 4000 User Manual page 75

4. Position one of the ZIP chips over the first empty socket
as shown below, aligning pin 1 on the chip (identified by
the notch on the top of the chip) with pin 1 on the system
board.
5. Gently press the chip halfway into the socket (to make sure
it is correctly aligned). If the chip does not go in smoothly,
remove it and try again.
6. When the chip is properly positioned, push down firmly on
both ends of the chip to make sure it is well-seated.
7. Repeat steps 4 through 6 to install the other chip in socket U3.
8. Replace any option cards you removed. See page 4-14 for
instructions.
9. Now run SETUP as described in Chapter 2 so that your
system recognizes the increased memory.
Installing and Removing Options
(U2)
4-21