Inserting Simms - Epson ActionDesk 4000 User Manual

S/MM configurations (continued)
BANK 0
16MB
32MB
32MB
32MB
32MB
32MB
32MB
32MB
Use only tin-plated, 32-bit or 36-bit, 72-pin, fast-page mode
SIMMs that operate at an access speed of 80ns (nanoseconds)
or faster. Be sure all the SIMMs operate at the same speed.
SIMMs that are 80ns must operate with 1 wait state; 70ns or
faster SIMMs can operate with 0 wait state. (To add a wait state,
select the
Chipset Control option in SETUP.)

Inserting SIMMs

Make sure the computer is turned off and then follow these
steps to install SIMMs:
1. Make sure the front of the computer is facing you.
2. Refer to the illustration on page 4-5 to locate the SIMM
sockets on the right side of the system board.
3. Remove any option cards that may be blocking your access
to the SIMM sockets. (See page 4-18 for instructions.)
BANK 1
32MB
X
1MB
2MB
4MB
8MB
16MB
32MB
wait state option from the Advanced
DRAM
installing and Removing Options
Total memory
48MB
32MB
33MB
34MB
36MB
40MB
48MB
64MB
4-11