Advertisement
FIELD SERVICE MODE ENTRY
Press and hold Start button while rotating the
cycle selection knob 180 degrees and then
release the Start button.
• Once service mode is entered all LEDs will
be flashing.
• The cycle selection Knob is now used to
control the test selection menu.
– Rotating the knob clockwise will increment
the test numbers in the
display.
– Rotating the knob counter clockwise will
decrement the test number in the display.
– Turning the knob to go to a different test will
terminate any current active state
• Once the test number is selected, pressing
Start will begin the selected test.
• Once the test number is selected, pressing Start
will begin the selected test.
Exit Field Service Mode
• Field service mode will time out after 30 minutes
if there is no user activity.
• Press Power button
SERVICE MODE TEST 17-
Change Personality
Pressing Start will start the test. Press Start
button again and the next valid personality should
be displayed. Press and hold the Start button to
select the correct personality. The control will go to
an idle state. All LED's off.
Note: If the personality ID is already set and you
try to set the same personality the control will
NOT go to an idle state. Ensure the correct
personality ID is being entered.
2
Advertisement
