Power Steering Unit Installation - Polaris RZR 900 2017 Service Manual

STEERING / SUSPENSION

POWER STEERING UNIT INSTALLATION

1. If the power steering unit
w
mount bracket , reinstall it prior to vehicle
installation. Torque the mounting bolts
specification.
TORQUE
Power Steering Unit Mounting Bolts:
30 ft-lb (41 Nm)
2. Install the power steering unit into the vehicle and
align the skip-tooth spline
stub shaft with the opening in the lower steering shaft
t
.
3. Place the power steering mount bracket over the top
of the brake pedal mount studs and finger tighten the
four nuts.
9.14
q
was removed from the
e
to
r
on the power steering
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
4. Torque the four mount bracket nuts
specification.
TORQUE
Power Steering Unit Mount Bracket Nuts:
16 ft-lb (22 Nm)
5. Position the lower steering shaft on the power
steering unit stub shaft and install the pinch bolt.
Torque to specification.
TORQUE
Lower Steering Shaft to EPS Unit Pinch Bolt:
15 ft-lbs (20 Nm)
6. See Chapter 8 – Upper Steering Shaft Installation
page 9.15 to complete the installation procedure.
y
to
© Copyright Polaris Industries Inc.