Electrolux FSF3 Installation, Use And Maintenance Instructions page 24

 Do not expose the machine to wind, rain or extreme
temperatures.
 Single person operation only.
 When the cycle has begun, the machine automatically
performs the programmed operations including the
movement of mechanical parts, do nothing and keep a
safety distance, in case you need to stop the machine use
the red mushroom "Emergency-Stop".
 This machine is not suitable to be used by persons
(including children) with reduced physical, sensory or
mental capabilities, or with no previous experience and
knowledge of this machine, unless they have been given
supervision or instruction concerning use of the machine.
 Inspection, repair and technical maintenance may only be
performed by a qualified technician and with the
necessary safety protections (gloves , shoes,etc).
 In case of damage or malfunction, immediately switch off
the machine and disconnect electricity, Never try to
disassemble but call technical service. It could cause
injury or further damage.
 Before removing any panels of the machine for
maintenance or to carry out any work. Make sure the
following are switched off: power supply, compressed
air and steam; moreover, the hot parts of the machine
must be left to cool and the compressed air in the
machine must be discharged.
 Always place the machine on a dry, flat and weight-
resistance surface. It is necessary to keep the unit in
horizontal position during operation.
 Do not place the machine near a source of heat (live
element, electric stove...) or inflammable materials
(explosive, ignitable gases...).
 Keep the ventilation slots of the machine clear. Danger of
overheating!
 Mark the working area (to encompass the machine with
fully extended moving parts); we recommend a minimum
distance of 60cm from the work area for maintenance, the
positioning of other machines and, if required, for
passage.
 Before connecting the machine, make sure that the
mains voltage and the frequency are the same as
indicated on the technical specifications and that the
electrical supply line must be fitted with an automatic
differential heat safety
mechanical plug and socket block. This plug must be
able to support the power absorbed by the machine
and must be connected to a good earth (for technical
SITE
ELECTRICAL
cut-out switch
specification
electric system must comply with the existing
rules and laws.
 Do not put the machine, the cable or the plugs in
water or other liquids.
 Do not place the electrical cable over sharp edges or
close to hot surfaces or objects; do not allow the
electrical cable to be twisted, crushed or stretched,
as this will damage the cable.
 Do not use the machine if the electrical cable or other
important parts are damaged. If you have to replace
some parts, please contact the qualified and
authorised service centre.
 Do not use the machine near sinks, bathtubs,
showers or containers full of water. Never touch the
machine with wet hands or feet when plug is
connected. Do not use the machine when barefoot.
 Do not leave the machine unattended during
functioning and not until it is is completely cooled
down after switching off. If not used, switch it off by
means of the proper switches and take off the
connections (power, water, steam, condensate and
air).
BURNS AND CRUSH HAZARD
 Identification hot areas:
1 – dummy
2 - connections and steam/condensation hoses
 The hot areas are covered with insulating material to
avoid burns in case of accidental contact; do not
remove them and use the machine only with this
material, replace when damaged.
 During functioning and until complete cooling, do
not touch the hot areas of the machine with bare
hands (with the exclusion of the working areas 1).
Turn the steam tap/knob using insulating gloves for
the heat.
 Identification
hazard) and moving part areas (crush hazard):
3 – front press
4 – rear press
5 – shoulder press
6 – cuff placket press
with a
- 4 -
see "Technical section").
high temperature areas
The
(burn