Service Note - Sony FDR-X3000 Service Manual

3-1. PRECAUTION ON REPLACING THE SY-1069 BOARD
The board for repair is not recorded the information unique to a model. Therefore the following data are needed to write.
Note: The "LOAD AND WRITE" function in "ADJUSTMENT DATA BACKUP" on the DATA tab in the Adjust Manual overwrites all data of the unit.
Therefore execute the "LOAD AND WRITE" before performing the following operation.
DESTINATION DATA
When you replace to a board for service, the written destination data of the board for service also might be changed to original setting.
USB SERIAL SAVE
When you replace to a board for service, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform "USB SERIAL SAVE" to get the data.
USB Serial No. and Product ID
The unit is shipped after an ID (USB Serial No.) unique to each unit and an ID (Product ID) unique to each model have been written.
These IDs have not been written in a new board for service, and therefore they must be entered after the board replacement.
After the board has been replaced with a board for service, start the Adjust Manual in the Adjust Station and execute the "PRODUCT ID &
USB SERIAL No. INPUT" and enter these IDs.
Note: A newly entered Product ID is not always equal to the ID before board replacement. If the new ID differs from the previous ID, it may cause a difference
from the ID registered by the customer.
Update of MAC Address
When replacing the SY board, the CPU's unique number (MAC address) must be reloaded. Perform the following procedure to reload the
CPU's unique number (MAC address).
1. Download the latest-version Adjust Manual.
2. Install the downloaded Adjust Manual.
3. Execute "Wi-Fi & BT Setting (MAC address)" on the ADJUST tab.
Password required for Wi-Fi connection
A password required for Wi-Fi connection is recorded in every SY board. A label to present the password to the customer is stuck to every SY
board for service. When the SY board is replaced, attach this label to the unit to be sent back.
Note 1: The new SSID and password can be checked on the PC connected to the unit with a USB cable.
[Computer] → [PMHOME] → [INFO] → [WIFI_INF.TXT]
Note 2: When succeeding the data from the board before replacing to new board for repair by using The "LOAD AND WRITE" function of "ADJUSTMENT
DATA BACKUP" in the DATA tab of Adjust Manual, perform following operations. The seal that is attached former board for repair is not needed.
1. Reset the unit.
2. Download the WIFI_INF_CREATE.zip and generate "WIFI_INF.txt" file to the PMHOME folder of the unit by using the tool.
TEBURE Data
When replacing the SY repairing board, be sure to extract the TEBURE data from the former SY board beforehand. After replacing the SY
board, execute "Lens Data Carry for Shake Cancelling" on the Adjust manual to write the extracted TEBURE data.
Note:
• If you cannot extract the TEBURE data from the former SY board, please contact to each HQ. Acquire the TEBURE data with serial number
of the unit.
• When replacing the lens device, refer to "3-2. NOTES ON REPLACING THE LENS".
Lens device replacement
Read the QR code
(TEBURE Data)
Write the TEBURE data
(Perform "Lens Data Carry for Shake Cancelling" on the Adjust Manual)
FDR-X3000/X3000R/HDR-AS300/AS300R

3. SERVICE NOTE

SY board replacement
Extract
NG
TEBURE Data
OK
Contact to each HQ
(Acquires the TEBULE data from the
serial number of the unit or the lens)
3-1
– ENGLISH –