X522 Three-Phase Line Supply Voltage Sensing Up To 690 V (Phase-To-Phase); Significance Of The Leds For The Voltage Sensing Module Vsm10 - Siemens SINAMICS G130 Operating Instructions Manual

Electrical installation
4.3 Interface description
4.3.5

X522 three-phase line supply voltage sensing up to 690 V (phase-to-phase)

Table 4- 5 Terminal block X522
Terminal
1
2
3
Max. connectable cross-section: 6 mm²
NOTICE
Only one of the two terminals X521 and X522 may be used. Nothing may be connected to
the unused terminal.
NOTICE
The phases must be connected to the VSM10 with the same sequence as that of the Power
Module.
4.3.6

Significance of the LEDs for the Voltage Sensing Module VSM10

Table 4- 6 Significance of the LEDs on the VSM10
LED Color
RDY ---
Green
Orange
Red
Green / red
Green / orange
or
red / orange
18
Designation
Phase voltage U
Phase voltage V
Phase voltage W
Status
Off The electronics power supply is missing or lies outside permissible
tolerance range.
Steady light The component is ready for operation and cyclic DRIVE-CLiQ
communication is taking place.
Steady light DRIVE-CLiQ communication is being established.
Steady light At least one fault is present in this component.
Note:
The LED is driven irrespective of the corresponding messages
being reconfigured.
Flashing, 0.5 Hz Firmware is being downloaded.
Flashing, 2 Hz Firmware download is complete. Waiting for POWER ON.
Flashing, 2 Hz Detection of the components via LED is activated (p0144).
Note:
Both options depend on the LED status when module recognition
is activated via p0144 = 1.
Technical specifications
Directly connected to sense the line supply
voltage
Description
Voltage Sensing Module 10 (VSM10)
Operating Instructions, 03/2012, A5E02142235A