Dtc P2102: Throttle Actuator Control Motor Circuit Low - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:
Table of Contents

Advertisement

DTC P2102: Throttle Actuator Control Motor Circuit Low

Wiring Diagram
Refer to "DTC P2101: Throttle Actuator Control Motor Circuit Range / Performance: For Petrol Engine Model".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Power supply voltage of throttle actuator control circuit is
less than 5 V for specified time even if throttle actuator
control relay is turned on.
(1 driving detection logic)
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Start engine and run it for 1 min. or more.
4) Check DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions for DTC Troubleshooting: For Petrol Engine Model".
Step
1
Was "Engine and Emission Control System Check"
performed?
2
Throttle actuator control relay circuit check
1) Remove ECM from its bracket with ECM connectors
connected.
2) Check for proper connection of ECM connector at "E23-
50" and "E23-17" terminals.
3) Turn ON ignition switch.
4) Measure voltage between "E23-17" terminal of ECM
connector and engine ground.
Is voltage 10 – 14 V?
3
Is "THR MOT" fuse in good condition?
4
Throttle actuator control relay circuit check
1) Remove throttle actuator control relay from relay box
with ignition switch turned OFF.
2) Check for proper connection to throttle actuator control
relay at "BLU/BLK", "BLU/RED", "BLU/ORN" and "GRN"
wire terminals.
3) Measure voltage between engine ground and each
"BLU/BLK", "BLU/RED" wire terminal with ignition switch
turned ON.
Is each voltage 10 – 14 V?
Engine General Information and Diagnosis: For Petrol Engine Model 1A-196
Action
Trouble area
• Throttle actuator control relay circuit
• Throttle actuator control relay
• ECM
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Go to Step 4
Go to Step 5
S6JB0A1114069
No
Go to "Engine and
Emission Control
System Check: For
Petrol Engine Model"
Go to Step 3.
Replace fuse and check
for short in circuits
connected to this fuse.
"BLU/BLK" wire and/or
"BLU/RED" wire is open
or high resistance.

Advertisement

Table of Contents
loading

Table of Contents