Motorola HMWS1060 Quick Start Manual page 8

Water Sensor
Wall Mounting Drilling Template
Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, Motorola recommends that you
pre-drill ½ inch deep pilot holes with a drill bit slightly smaller than the mounting screws before secur-
ing the sensor to the surface. When mounting a sensor on soft surfaces like sheetrock, use an awl to
punch holes in the material slightly smaller than the plastic anchors included in the hardware mounting
kit.
The illustrations are drawn to a one-to-one scale which means they provide the exact dimensions required to
mount the unit.
Sensor Mounting Template
Top
Drill Holes In
These Positions
0.27 in
Quick Start Guide
Page 5