Table of Contents
Advertisement
BEACON INSTALLATION - INTRODUCTION
The wiring loom and mounting bracket are supplied with the
cab. The mounting bracket can be attached to the right or left
side of the cab as required.
BEACON INSTALLATION - ASSEMBLY
1. Disconnect the negative (-ve) battery lead first and then
disconnect the positive (+ve) battery lead.
2. Remove the cab roof to gain access to the beacon wiring
loom connector.
3. The beacon mounting bracket utilises the two bolts that
secure the air-conditioning assembly to the rear cab posts.
If the air-conditioning is not fitted then secure the mounting
bracket (item 10) to the air-conditioning mounting lugs
using the new bolts (items 11, 12, 13) supplied with the
beacon kit.
4. Bolt the upstand (item 2) to the mounting bracket using
items 3, 4, 5, 6 and tighten sufficiently so that it can be
raised and lowered but is held in position when released.
5. Bolt the beacon to the top plate of the upstand using items 7,
8, 9.
6. Connect the wiring loom (item 16) to the fuse box with the
live wire (orange and as shown in Fig 50). Connect the
black wire the earth terminal (as shown in Fig 50). Connect
both the switch (item 16) and the connector as shown in
Fig 50. Connect the leads (A & B shown in Fig 51) on the
beacon to the wiring loom in the roof space of the cab.
7. Insert the fuse into slot no. 3. Refer to Fig 50.
8. Re-fit the cab roof.
9. Re-connect the positive (+ve) battery lead first and then re-
connect the negative (-ve).
10. Turn the ignition switch to the 'I' position and depress the
beacon switch to check that the beacon illuminates and
rotates correctly.
Issued: 01.04.11
Approved:
Mod. No.
5060358
Sheet 44 of 64
Part No. 111-4431 (A)
Advertisement
Table of Contents
