Siemens 1MB115 Installation And Maintenance Manual page 86

3.2 Preparations
3.2.1 Preparing the assembly area
1. Prepare a suitable assembly area (e.g. assembly stands). Make sure that the
assembly area has sufficient clearance from the floor for the DE shaft end.
The necessary data is provided in the machine dimension drawing.
2. Using the shipping papers, check whether all of the motor components are
available for assembly.
• For vertical installation, use all of the eyebolts provided and when
necessary, hoisting straps (DIN EN 1492-1) and/or lashing straps (DIN EN
12195-2) to stabilize the position of the motor.
• Prevent foreign bodies from falling into the fan cover. For vertical machine
installation with the shaft end facing downwards, attach a protective
canopy.
• If the shaft extension is facing upwards, the user must prevent liquid from
moving along the shaft and entering the motor.
• Clean bare metal surfaces with anti-corrosion agent using white spirit to
ensure proper installation and / or machine mounting.
• Do not obstruct the ventilation! Do not draw in the discharged air directly –
also from adjacent equipment.
• Avoid exposing them to direct, intense solar radiation, rain, snow, ice, or
also dust for extended periods. Attach a covering structure or an additional
cover when using or storing outdoors.
• Do not exceed the permissible axial and radial forces.
• Only use explosion-protected machines in appropriate areas in compliance
with local directives.
If the certification is supplemented by an X, please note the special
conditions in the EC type examination certificate.
• When installing electrical systems in hazardous zones, observe EN/IEC
60079-14 and the corresponding country regulations.
• The machine temperature class specified on the rating plate must be equal
to or greater than the temperature class of any combustible gases that may
develop.
• Select optional mounted equipment according to the requirements of local
directives.
86