Hitachi air Home RC-AGU1EA0S Manual page 9

Mold Guard Operation
After the cooling operation is stopped, the fan of the indoor unit is dried by fan mode to suppress the generation of
●
mold inside the indoor unit.
– Mold Guard Operation period is about 1 hour.
– It can't remove mold or sterilize.
More than 10 min.
Cooling or Dehumidify
operation
Running
● " " Lamp on the indoor unit lights up during Mold Guard operation.
When the air conditioner operates in cooling or drying mode for more than 10 minutes and then put into off mode,
●
the mold guard operation will start.
● Room temperature or humidity may rise
NOTE
If operation of Unit is stop by Off Timer or GoodSleep Timer, the Mold Guard will not operate.
●
If On Timer is set and on time is within about 2 hours, the Mold Guard will not operate.
●
Depending on situation, Mold Guard will operate with Fan Mode.
●
Room temperature or humidity may rise.
●
When there is window near the indoor unit, the water might condense on the window during Mold
●
Guard. If necessary, cancel Mold Guard.
The Process of Mold Guard
Mold Guard
The defl ector remains open.
Stop
■ How to set and cancel Mold Guard
For setting
● Press the button and
1
during air conditioner operation stop.
" " is displayed on the LCD.
●
For cancelling
● Press the button and
2
during air conditioner operation stop.
" " is disappear on the LCD.
●
Once Mold Guard function set, Mold Guard icon will always display on the
●
LCD. And it stored in the memory of remote controller and remain set even
after reset or battery replacement case. It is one time setting procedure to
use this function.
■ How to stop at middle point of Mold Guard operation
Press the (On/Off) button twice, the operation will stop.
●
3
" " Lamp on the indoor unit turns off. But setting for Mold Guard
●
will not cancel, it will stop the current operation only.
– 9 –
About 60 min.
(On Timer) button 3 seconds together
(On Timer) button 3 seconds together