Disturbance Identification - ABB ABILITY SSC600 Operation Manual

1MRS758850 D
• Check: compare the contents of the backup and current device state. Check fails
if the contents do not match, and passes if they match.
This view also shows the newly added, factory-reset devices, with IP address
192.168.2.10 (see bottom-most device in
backups can be deployed to this device. There can only be one factory-reset
device visible at a time, otherwise IP address conflict would occur.
Figure 30: Backup view
4.2

Disturbance identification

Disturbances and their causes can be identified by physical or WEB HMI indicator
LEDs: Ready, Start and Trip. During normal operation, the Ready LED is steady
green.
Table 10: Physical LED indications
LED
Start LED
Start LED
Trip LED
Ready LED
Alarm LED
SSC600
Operation Manual
Figure 30 ). Any of the existing
State
Green, steady
Green, flashing
Green, steady
Green, flashing
Green, steady
IED operation
Description
Protection started
Protection function blocked
Protection operated
Internal fault
Programmable LED in alarm
state
47