Card Replacement Process
Step 5
Step 6
Step 7
Step 8
Cisco 3200 Series Router Hardware Upgrade Guide
3-8
Get user manuals:
See SafeManuals.com
Slide the card stack into the front of the enclosure, as shown in
cards as necessary to fit the slots. You can use a flat-blade screwdriver to make adjustments.
Figure 3-7
Inserting the Card Stack Into the (or Body) of the Rugged Enclosure
Place the extrusion horizontally on the flat surface.
Push the card stack farther until the card stack starts coming out from the I/O end cap side of the
enclosure.
Using a small Phillips screw driver, attach the alignment tabs to the Mobile Access Router Card
(MARC), as shown in
Figure
Chapter 3
Replacing Cards in the Cisco ISR 3270 Rugged Enclosure
3-8. Use a torque range of 2.5 to 3.5 in-lb.
Figure
3-7, adjusting the spacing of the
OL-15983-01