Positioning And Levelling; Electrical Connection - LG FA415RMA Owner's Manual

Positioning and levelling

Positioning the appliance
When installing the appliance, make sure that there is
enough space in the final installation location to pull
the appliance forwards for cleaning and maintenance
work.
The ground underneath must be hard and stable.
The wall immediately behind the appliance must be
made from non-flammable material, e.g. tiles.
If you need to pull the appliance in order to position
it, make sure that the adjustable feet are screwed in
fully.
Levelling the appliance
Level the appliance once all other work has been
completed.
Use a leveler to verify the adjustments. Place leveler
diagonally over shelf and check all positions to level.
To do this, turn the adjustable feet.
CAUTION
• THE APPLIANCE MUST SIT
LEVEL ON THE FLOOR TO
ENSURE STABILITY.
• SCREW OR UNSCREW THE
BOTTOM PART OF THE FEET
UNTIL THE APPLIANCE IS
STABLE AND LEVEL ON THE
FLOOR.
• THE LOWER THE HEIGHT OF
THE FOOT, THE MORE STABLE
THE APPLIANCE. IF THE
APPLIANCE IS UNSTABLE,
ADJUST THE HEIGHT OF THE
FEET.
WARNING
• IF THE FEET ARE ADJUSTED
APPROPRIATELY, IT IS
REQUIRED NOT TO MOVE THE
APPLIANCE BY DRAGGING, IT
SHOULD BE MOVED BY LIFTING
IT UP. OTHERWISE, THE FEET
AND BASE PLATE MAY BE
DEFORMED AND DAMAGED,
AND THE APPLIANCE MAY
BECOME UNSTABLE.

Electrical connection

Only a licensed expert may connect the appliance.
The appliance must be installed according to the
most recent IEE regulations (Institute of Electrical
Engineers).
The appliance could become damaged if incorrectly
connected.
Make sure the voltage of the power supply
corresponds to the specified value on the rating plate.
The rating plate can be found on the inside of the
storage compartment flap.
Ensure that the power supply is properly earthed and
that the fuse and the wiring and piping system in the
building can withstand the load from the appliance.
It is recommended that you configure the circuit for
the appliance to 16 A.
Nominal Electrical Features
• 220-240 V, 50/60 Hz, 54.1 W
When you route the mains cable, make sure that:
• the cable is not trapped or squashed.
• the cable does not come into contact with sharp
edges or cutting edges.
• the cable does not come into contact with parts that
can reach temperatures of more than 50 °C above
room temperature.
Connecting the mains cable
Where the appliance is directly connected to the
power supply, an all-pole isolating switch with a
contact gap is required.
Complete disconnection in compliance with the
conditions specified in overvoltage category III must
be guaranteed.
The earth cable is excluded from this.
INSTALLATION 15