Electrical Connection For Appliances With Plug; Electrical Connection For Appliances With Cable Without Plug; Installation Of Multiple Appliances - Electrolux SafeBox Hold Installation And Operating Manual

The appliance must also be included in an equipotential
system, whose connection is made by means of equipotential
screw indicated by the symbol
The equipotential wire must have a section of at least 10 mm2.
E.7 Electrical connection for appliances
with plug
• To connect to the power supply, insert the power cable plug
in the corresponding mains socket, first making sure:
– the socket has an efficient earth contact and the mains
voltage and frequency match that given on the dataplate. In
case of any doubts regarding the efficiency of the earth
connection have the system checked by specialised
personnel.
– the system power supply is arranged and able to take the
actual current absorption and that it is correctly executed
according to the regulations in force in the country of use.
• The plug must be accessible after positioning the appliance
in the place of installation.
• The plug must be in a position always visible to the operator
performing the intervention during maintenance operations.
E.8 Electrical connection for appliances
with cable without plug
• The connection point has an efficient earth contact and the
mains voltage and frequency match that given on the data
plate. In case of doubts regarding the efficiency of the earth
wire, have the system checked by specialised personnel.
• The appliance must be permanently connected to the
power supply, respecting the polarities:
– brown/black/gray: phase
– yellow/green: earth
– blue: neutral
• The differential thermal-magnetic switch must be lockable
in the open position in case of maintenance.
E.9

Installation of multiple appliances

WARNING
For maximum installation height
and stackability refer to para-
graph A.10
assembly.
In case of stacked appliances, plug at least one into the main
power socket.
14
.
Installation and
A. Lower appliance
B. Upper appliance
To install multiple appliances on top of each other, follow
these steps:
1. Remove the feet from the appliance "B".
IMPORTANT
Make sure the gasket is present so you don't
damage the top surface of the appliance "A".
2. Remove the screws from the rear supports of appliance
"A", rotate them 180° and reinsert the screws to fix them.