Table of Contents
Advertisement
DTE (Data Terminal Equipment), defined 57
DTYPE command 29
use of 46
DUMP command 29
E
Enable/disable
continuous keying (CKEY command) 27
internal RTU (RTU command) 35
network-wide diagnostics (DLINK command) 28
network-wide diagnostics, procedures 46
Environment specifications 44
Equalization, defined 57
F
Fade margin, defined 57
Feedlines 11
firmware
installing 50, 52
Frame, defined 57
Frequency
setting. See TX and RX commands
G
Glossary 56
H
Half-duplex 7
switched carrier operation 8
Hand-Held Terminal (HHT)
entering commands 21
Hardware flow control, defined 57
Host computer, defined 57
I
IEC
61000-4-5 Annex A 18
IEC61850-3 18
Illustrations
antenna, Yagi 11
MAS network 7
network-wide diagnostics 45
point-to-point link 7
remote station arrangement 9
INIT command 30
INIT xx10 command 30
INIT xx20 command 30
InSite software
using to perform remote diagnostics 45
Installation
antenna 18
power 18
power connection 12, 13
Intrusive diagnostics (defined) 57
K
KEY command 31
Keying
continuously keyed versus switched carrier operation 8
continuously keyed, defined 8
on data (DKEY command) 28
switched carrier, defined 8
L
Latency, defined 57
MDS 05-4670A01, Rev. E
LEDs
PWR 19
status indicators, illustrated 19
Loss. See Signal
M
MAS (Multiple Address System) 6
defined 57
illustration 7
Master Station
defined 57
keying behavior 8
MODEL command 31
Model number codes 6
displaying (MODEL command) 31
MODEM command 31
Modem, set speed. See MODEM command
Mounting instructions 9
Multiple Address System—See MAS. 57
N
Network-wide diagnostics
active messaging, defined 56
defined 57
enable/disable (DLINK command) 28
enable/disable internal RTU (RTU command) 35
illustrated 45
intrusive diagnostics, defined 57
passive messaging (defined) 58
procedures 44, 46
set radio to root or node (DTYPE command) 29
Non-intrusive diagnostics—See Passive messaging. 57
O
Operation 21
environment specifications for 44
OWM command 33
OWN command 33
Owner's message, set/display. See OWM command
Owner's name, set/display. See OWN command
P
Passive messaging (defined) 58
Payload data (defined) 58
PLC (Programmable Logic Controller), defined 58
Point-to-multipoint
defined 58
system 6
Point-to-point
link, illustrated 7
system 7
Poll, defined 58
Power
connection 12, 13
display DC voltage (SHOW command) 36
display RF output (SHOW command) 36
installing 18
LED status indicator (PWR LED) 19
RF, chart for converting dBm-Watts-Volts 55
specifications 44
Procedures
checking for alarms (STAT command) 40
downloading new software 48
entering commands using the Hand-Held Terminal
(HHT) 21
SD Series Reference Manual (x710 Mode)
I-2
Advertisement
Table of Contents
