Advertisement
ENGLISH
H
I
ARDWARE
1.
Turn off PC and disconnect all power cords.
2.
Remove the PC cover from computer.
3.
Set the Master/Slave jumper on DVD-ROM rear panel according to the following section.
4.
Find an empty bay, slide the DVD-ROM into the bay horizontally and mount the drive
with 4 screws.
5.
Connect the power supply cable to DVD-ROM drive.
Ensure the pin definition of power connector is the same as shown in figure 1.
6.
Connect the 40-pin E-IDE cable to DVD-ROM according to the description in the
following section.
7.
Connect the sound cable from the Analog Audio on the rear panel of DVD-ROM to
sound card if you have a sound card in your system.
8.
Put the PC cover back and connect the power cords.
9.
Connect the power cord to an AC outlet and turn on computer.
Set Master or Slave Jumper
There are three pairs of jumpers, MA(Master), SL(Slave) and CS(CSEL) on the rear panel of
your DVD-ROM drive. Figure 1 shows the location of the jumper.
DIGITAL
ANALOG
AUDIO
AUDIO
DG
RGGL
The Master/Slave jumper can be used to set the DVD-ROM drive to Master or Slave device.
Figure 2 is the illustration of jumper setting.
NOTE: Do not use two jumpers to set MA and SL simultaneously.
2
NSTALLATION OF
CABLE SELECT
SLAVE
HOST INTERFACE
MASTER
C
S
M
39
S
L
A
40
Figure 1: Rear panel of DVD-ROM drive
S
M
C
L
A
S
Master Device
Figure 2: The setting of Master or Slave device.
ATAPI/E-IDE D
POWER
1
2
+5
G
S
M
C
L
A
S
Slave Device
(Default setting)
RIVES
G +12
Advertisement
